What is Runn™?
The Runn™ wireless treadmill sensor was built to stream real time speed, distance, incline and cadence data over Bluetooth to connected fitness applications such as Zwift™ that support the Bluetooth fitness machine service.
What is included with Runn™?
- Runn™ sensor
-
Runn™ mounting cradle
-
Belt sensor stickers
- 3M® VHB adhesive strips
-
USB charging cable
Charging Your Runn™
Runn™ takes approximately 1.5 hours to charge from 0% to 100%. During a 1 hour workout, Runn™ uses approximately 5% to 6% of its battery.
Where to Mount Your Runn™
The Runn™ installation works best when you mount the Runn™ on a flat part of the treadmill out of the way so that you do not hit it while exercising.
Installing Your Runn™
- Clean the treadmill surface where you want to mount your Runn™.
- Temporarily set the Runn™ onto the treadmill deck ensuring the Runn™ speed sensor pickup is over the treadmill belt.
- Adjust the Runn™ height in the cradle so that the Runn™ speed sensor pickup is .25” to .5” (.6 to 1.2 cm) away from the treadmill belt. You can use a pen or pencil and put it underneath the speed sensor pickup to gauge the distance needed between the treadmill belt and speed sensor pickup.
- Place 2 to 3 of the belt sensor stickers on the treadmill belt horizontally at least 18” apart. Use the circles on the front of the Runn™ to help with aligning the belt sensor stickers to the Runn™ speed sensor pickup.
- Turn on your treadmill. Press the button on the back of the Runn™ twice and the right LED should light up. Single press the button to turn on Sensor Strip Detection Mode. As belt sensor stickers pass underneath the Runn™ speed sensor pickup, the left and right LEDs will toggle indicating successful alignment of the belt sensor stickers to the Runn™ speed sensor pickup. If the Runn™ LEDs don’t toggle, adjust the Runn™ and belt sensor stickers’ placement as necessary.
- With the Runn™ positioned correctly, firmly mount the Runn™ using the included 3M® adhesive tape.
Connecting via Bluetooth
- Open up your desired fitness app or sensors menu of you wearable device.
- Select your Runn™ for your sensors for speed, cadence, and incline.
- Enjoy your Runn™!
Connecting via ANT+
- Double press the white button on your Runn™ to turn on the ANT+ radio. The right LED will turn on.
- Open up your desired fitness app or sensors menu of you wearable device.
- Select your Runn™ for your sensors for speed, cadence, and incline.
- Enjoy your Runn™!
Comments
0 comments
Please sign in to leave a comment.